Weee Waste Electrical and Electronic Equipment Household Electric Plastic Flakes Spin Dryer Dehydrator Machine

Description

Material to be dried enters the dryer, and as the dryer rotates, the material is lifted up by a series of internal fins lining the inner wall of the dryer. When the material gets high enough to roll back off the fins, it falls back down to the bottom of the dryer, passing through the hot gas stream as it falls. This gas stream can either be moving toward the discharge end from the feed end (known as co-current flow), or toward the feed end from the discharge end (known as counter-current flow). The gas stream can be made up of a mixture of air and combustion gases from a burner, in which case the dryer is called a direct heated dryer. Alternatively, the gas stream may consist of air or another (sometimes inert) gas that is preheated. When the gas stream is preheated by some means where burner combustion gases do not enter the dryer, the dryer known as an indirect heated type. Often, indirect heated dryers are used when product contamination is a concern.

Features:

Being adapted the heating way of jacket and inner stirring at the same time, its heat conducting area is large and its heat efficiency is high.
Being installed stirring in the machine, it makes raw material in the cylinder form the state of continuous circle inside the
cylinder, so the uniformity to be heated of raw material is raised greatly.
Being installed stirring apparatus in the machine, pulpiness, pastelike mixture or powder raw materials can be dried easy.